Arterial duplex is a combined gray-scale, color Doppler, and spectral Doppler examination of the peripheral arteries. It maps plaque, grades stenosis with peak systolic velocity and velocity ratios, and distinguishes occlusion from a residual lumen when pulses, the ankle-brachial index, or symptoms raise concern for peripheral artery disease. This guide is written for clinicians who perform or interpret the study. It covers lower-extremity protocol, waveform analysis, commonly cited velocity criteria, and pitfalls that lead to overcalling or undercalling disease.
When Arterial Duplex Is the Right Test
Order an arterial Doppler duplex study when you need anatomic detail that a physiologic test cannot provide. Typical indications include claudication that limits function, rest pain, nonhealing foot or toe wounds, an abnormal ankle-brachial index, diminished or absent pulses, and surveillance after bypass or stent placement. Pre-procedure mapping of inflow, outflow, and conduit vessels is another common request. Upper-extremity studies are used for arm ischemia, suspected subclavian steal, and dialysis access planning. Extracranial carotid disease is a separate examination with its own protocol and criteria, described in our review of carotid artery duplex ultrasonography.
Arterial duplex does not replace a pulse examination or ankle-brachial index. Those tools remain the first-line screen. Duplex adds lesion location, the distinction between stenosis and occlusion, and a baseline for later comparison. It is not the study of choice for suspected deep vein thrombosis; that question is answered with duplex venous ultrasound.
Lower-Extremity Arterial Duplex Protocol
Rest the patient supine in a warm room for several minutes before scanning. Cool skin and recent tobacco use increase peripheral resistance and can damp a normal high-resistance waveform. Use a high-frequency linear transducer for the thigh and calf. Switch to a lower-frequency linear or curved transducer for the iliac arteries, a large body habitus, or a densely calcified superficial femoral artery.
A complete native lower-extremity exam usually includes gray-scale, color, and spectral Doppler at these stations:
- Distal external iliac or common femoral artery, with the profunda femoris origin
- Proximal, mid, and distal superficial femoral artery
- Popliteal artery
- Tibioperoneal trunk
- Anterior tibial, posterior tibial, and peroneal arteries
- Pedal arteries when runoff or distal targets matter
At each station, document visible plaque, color fill, a spectral waveform obtained at 60 degrees or less, and peak systolic velocity. When color aliasing, a velocity step-up, or plaque suggests a lesion, sample immediately proximal to the stenosis, at the jet, and just distal so a velocity ratio can be calculated. This duplex arterial mapping should be continuous from a known landmark so a collateral is not mistaken for the native vessel. Short-axis color helps confirm occlusion versus a residual string-sign lumen.
Inflow disease changes every downstream waveform. If common femoral waveforms are monophasic or the picture suggests aortoiliac disease, extend the exam through the iliac arteries. Graft and stent exams follow the conduit from inflow to outflow, with extra samples at anastomoses, known kinks, and the native vessel beyond the reconstruction.
Waveforms and Doppler Settings That Affect the Call
Resting extremity arteries normally show a high-resistance pattern: sharp upstroke, a brief reverse-flow component in early diastole, and smaller forward flow in late diastole. Many labs still call this triphasic. Distal to a hemodynamically important stenosis, reverse flow is lost, upstroke slows, and the waveform becomes monophasic and low resistance. A focal high-velocity jet with spectral broadening sits at the lesion itself. Consistent arterial and venous Doppler waveform nomenclature across readers reduces reports that sound abnormal when the tracing is simply high resistance and normal.
Keep the sample volume small and in the center stream. Align the Doppler cursor with the jet, not automatically with the vessel wall, when plaque deflects flow. Use an angle of 60 degrees or less; error rises steeply above that, as discussed in our article on ultrasound physics at the scanner. Scale color so native flow is just below aliasing and a stenosis stands out as a mosaic. Wall filters that are too high erase true diastolic flow and can make a low-velocity reconstituted vessel look occluded.
Velocity Criteria for Arterial Duplex Stenosis Grading
No single number grades every lesion. Peak systolic velocity varies with cardiac output, contralateral disease, tandem stenoses, and the vessel sampled. Most vascular labs therefore combine waveform change, a peak systolic velocity ratio, and an absolute velocity, and they apply internally consistent cutoffs.
For native lower-extremity arteries, commonly cited ranges are:
- Normal or less than 50 percent diameter reduction: triphasic or biphasic waveform, little spectral broadening, and a peak systolic velocity ratio below 2.0 compared with the proximal adjacent segment
- Fifty percent or greater stenosis: loss of the reverse-flow component distal to the lesion, focal spectral broadening, and a peak systolic velocity ratio of 2.0 or greater
- Seventy to 75 percent or greater stenosis: many labs use a ratio of 3.0 to 4.0, sometimes with an absolute peak systolic velocity of about 300 cm/s or higher
- Occlusion: absent flow in the native lumen, often with collaterals and a reconstituted distal vessel that fills late with a monophasic, low-velocity waveform
Published tables differ on the exact ratio that separates moderate from severe disease, and absolute velocity cutoffs are not interchangeable between the common femoral artery and a tibial vessel. State the ratio you used, the angles, and the proximal comparison segment. After bypass or stent placement, apply the criteria your lab validated for that conduit. A uniformly low-velocity, low-resistance graft waveform can indicate inflow trouble or a low-flow circuit rather than a single focal stenosis.
Pitfalls That Overcall or Undercall Disease
Most errors are technical or interpretive rather than a failure to see plaque.
- A Doppler angle above 60 degrees inflates peak systolic velocity and can create a false 50 percent stenosis.
- Comparing the jet with a post-stenotic, damped segment instead of a true proximal segment inflates the ratio.
- Calcified plaque shadows the lumen, and color may fail to fill a patent vessel. Change windows, drop frequency, and look for reconstituted flow distally.
- Tandem lesions and poor runoff lower velocity at a proximal stenosis, so a visually tight plaque may not reach ratio criteria.
- Compensatory flow through a profunda or a large collateral can raise velocity without a stenosis in that vessel.
- Arrhythmia, aortic stenosis, and low cardiac output alter upstroke and peak velocity in every bed.
- Color bloom can fill a near-occlusion and hide a string sign. Lower color gain and confirm with spectral Doppler.
When the waveform, the image, and the ratio disagree, resample. A high velocity with a still-triphasic distal waveform is more often angle error than a critical stenosis. A monophasic common femoral waveform with modest local velocities points above the inguinal ligament, not at the femoral bifurcation.
Accurate arterial duplex depends on a complete, angle-corrected protocol, internally consistent velocity ratios, and honest recognition of calcified plaque, tandem lesions, and inflow disease. IAME offers accredited ultrasound CME courses on Doppler waveform interpretation and related vascular duplex topics.
Frequently Asked Questions
What is an arterial scan?
In clinical practice an arterial scan usually means arterial duplex: gray-scale imaging of the vessel wall plus color and spectral Doppler of blood flow. The study maps plaque, estimates the degree of stenosis, and identifies occlusion in the arteries of the legs or arms. It is different from a venous duplex exam, which evaluates veins for thrombosis or reflux.
What are the warning signs of clogged arteries in the legs?
Clinical findings that should prompt consideration of peripheral artery disease include exertional calf, thigh, or buttock pain relieved by rest, rest pain in the forefoot, nonhealing wounds of the toes or heel, and diminished or absent pedal pulses. An abnormal ankle-brachial index supports the same concern. Arterial duplex then localizes the responsible lesions rather than standing alone as a diagnosis.
How long does a duplex scan take?
A focused, single-limb native arterial duplex often takes about 30 to 45 minutes of scanning time. Bilateral disease, iliac inflow assessment, heavy calcification, bypass grafts, and limited windows extend the study, sometimes beyond an hour. Allow extra time if an ankle-brachial index is performed in the same visit.
How does arterial duplex differ from an ankle-brachial index?
The ankle-brachial index is a physiologic screen that detects hemodynamically important disease somewhere in the limb but does not show where the lesion sits. Arterial duplex provides anatomic mapping, stenosis grade, and the distinction between stenosis and occlusion. The two tests are complementary, and many laboratories perform both when the question is peripheral artery disease.